Southbend S36D Bedienungsanleitung PDF herunterladen (Seite 18)

NSTALLATION

ERIES

ESTAURANT

ANGES

AGE

40 O

WNER

’

ANUAL

1191904

REV

(11/10)

TEP

TTACH

LUE

ISER AND

HELF

SSEMBLY

Place the flue riser assembly on the range as shown on the appropriate diagram below.

1. Slide the flue riser assembly over the bayonets until it bottoms out, as shown below.

2. Secure ends of flue riser assembly with two (2) 1/4-20 x 3/4 hex head bolts, flat washers and lockwashers.

3. Attach the shelf assembly (if ordered) to the flue riser assembly with 1/4-20 x 3/4 hex head bolts, flat washers

and lockwashers.

Figure 6

Installation of Flue Riser and Shelf Assembly

Single-Oven Models Dual-Oven Models

TEP

LECTRICAL

ONNECTION

Wiring diagrams are located on the rear of the range. Be sure that the input voltage and phase match the

requirements shown on the serial plate (see Figure 1 on page 3).

Ranges are factory-equipped either with a power cord or with one or two two-pole terminal blocks (one for each oven),

located behind cover plate(s) located on the rear of the range. To connect the supply wires, remove the appropriate

cover plate. Route the supply wires and the grounding wire through the strain relief fitting to the terminal block. Insert

the supply wires, one each, into the two poles of the terminal block and tighten the screws. Insert the ground wire into

the grounding lug and tighten the screw. Re-attach the cover plate.

Three phase ranges are wired as above, using only two supply wires. The third wire is not used and must be properly

terminated.

All ranges are shipped wired as specified by factory order. Conversion between single-phase and three-phase can be

accomplished by referring to phase loading and line amperes chart on wiring diagram for wire size and ampere

requirements.

TEP

ONNECTION

If this equipment is being installed at over 610 meters altitude and that information was not specified when ordered,

contact the appropriate authorized Southbend Service Representative or the Southbend Service Department. Failure

to install with proper orifice sizing will result in poor performance and may void the warranty.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 39 40

Kommentare zu diesen Handbüchern

Keine Kommentare

Southbend S36D Bedienungsanleitung Seite 18

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Herde Southbend S36D